Page 1 of 1

How to KILL an RFID chip?

PostPosted: Tue Jun 17, 2014 7:25 am
by FatJudy
i would like to destroy a RFID chip. Does anyone here know how I can do this? Please help.

Re: How to KILL an RFID chip?

PostPosted: Sun Jun 22, 2014 1:55 am
by Ron
google it.
there are 2 ways.
1. microwave
2. drive a nail through it.

Re: How to KILL an RFID chip?

PostPosted: Sun Jun 22, 2014 5:28 pm
by ericnelson
There is a side note to Ron's suggestions which is that if you microwave the item that the rfid is attached to you might melt the plastic. So you have to take that into consideration.

Re: How to KILL an RFID chip?

PostPosted: Tue Feb 03, 2015 4:34 am
by Alex23
FatJudy wrote:i would like to destroy a RFID chip. Does anyone here know how I can do this? Please help.


Not too sure about this but perhaps a small EMP gun might do the trick.

As for how you might come to acquire one of these i cant really say off hand if limited on funding.

I know sites that sell kits but they are rather pricey if you want the pieces (~$200)

Re: How to KILL an RFID chip?

PostPosted: Fri Sep 25, 2015 2:29 am
by Alex22
http://www.amazing1.com/pages/high-volt ... pulse.html

The low power pulse gun would probably destroy the circuitry of an RFID chip, although these chips are rare and they probably just want you to think you've been chipped.

Do not by any means dismember your body in any way in an attempt to remove a chip!!!

Better yet, it could be possible to detect the chip by buying a frequency counter from the same site or buying a real one from a site like www.lessemf.com (goes up to 6ghz.)